AL Rail-Split Extremetm
A 6 way RDM splitter for
electrically harsh environments
|
|
D
IN Rail 6
way RDM splitter with Fix mode.
Rail-Split extreme is a variant of Rail-Split RDM that is optimized for
harsh conditions and use in electrically noisy locations.
Both products
feature overvoltage protection (self-healing) on the input, loop and
all outputs.
Additionally,
Rail-Split Extreme provides surge protection. This feature is aimed at
protecting the product and connected equipment against voltage surges
of the type generated by lightning. The protection is sacrificial which
means that after a certain number of protection events, the protection
circuitry will be destroyed.
It is DIN Rail
mounted for ease of installation. All connections are via screw
terminals. DMX loop through and termination options are provided.
Rail-Split Extreme
supports the RDM (Remote Device Management) Standard. RDM allows
bidirectional communication over the DMX cable.
Rail-Split Extreme
is powered from a 9 to 48VDC power source. It uses 8 Watts.
Rail-Split Extreme
provides a switch to select between operation as a bidirectional
DMX/RDM splitter and Fix mode. In Fix Mode, the product discards all
RDM and other specialist data packets. It also adjusts the DMX timing
to values that are likely to be acceptable to fixtures that do not
fully comply with the DMX standard. The list below shows the fix mode
features.
Automatic timing
correction for DMX512.
Accepts breaks from
56uS to 1000uS
Accepts MAB from 5uS
to 1000uS
Accepts MBB from 0uS
to 1000uS
Accepts slot count
from 1-512
Accepts refresh from
23mS to 1000mS
Filters out
consecutive breaks
Retimes bytes with 1
stop bit to 2 stop bits
Generates DMX with
fixed timing parameters: Refresh = 33Hz, Brk=250uS, MaB=30uS, P=30mS,
C=512, MbB=30uS
Filters out all
Non-Zero Start Codes
Goddard Design Company
51 Nassau Ave.
Brooklyn
NY
11222
USA
718 599-0170718
599-0172 fax
©
copyright Goddard Design Co. 2009 last updated OCT,2021 |
|
|